Polyurea, silicone, and acrylic coatings that seal seams, reflect the sun, and shield roofs, floors, and more against UV, water, and wear — a tough, renewable finish you recoat instead of tearing off.
A sprayed or rolled elastomeric coating forms a seamless, flexible skin over your roof. It seals the seams, curbs and fasteners where leaks start, reflects UV to cut heat gain, and protects the layers underneath. When it ages, you clean and recoat the same surface — a renewable roof instead of a costly tear-off.
Bridges seams, penetrations and fastener heads — the spots where metal, built-up and membrane roofs usually fail first.
Light-colored coatings bounce sunlight off the roof, easing heat load on shops, warehouses and ag buildings in summer.
Recoat at the end of the coating's service life instead of a full tear-off — the roof renews rather than going to a landfill.
One of the toughest coating and lining technologies made — cures fast even in cold or damp conditions and bonds to almost any surface for a seamless, waterproof, abrasion-resistant shield on floors, containment and more.
Holds up to ponding water and heavy UV without breaking down — a strong fit for low-slope and flat roofs that hold water after a storm.
A cost-effective, highly reflective option for sloped metal and roofs that drain well. Water-based and easy to renew.
Every SPF roof we install is finished with a protective coating applied to manufacturer spec — it's what shields the foam from UV and weather.
Restore a rusting, leaking metal roof on a shop, barn or steel building without a tear-off.
Warehouses, storefronts and flat commercial roofs where ponding and open seams are the problem.
Already have a spray-foam roof? Recoating it on schedule is how you get decades of service out of it. See our SPF roofing page.
Based in Glendive, MT — serving the four-state region. Not listed? Call, we travel for the right job.
Silicone and acrylic elastomeric coatings, applied to manufacturer spec. Silicone stands up to ponding water and UV on flat roofs; acrylic is a cost-effective, reflective option. We match the coating to your roof and climate.
Yes. A coating over a prepped metal roof seals rusting seams and fastener leaks and adds a reflective layer — a common fix for shop, barn and steel buildings in our region.
The coating is the wear layer. When it reaches the end of its service life you clean and recoat the surface instead of tearing the roof off — the roof renews rather than going to a landfill. Call for specifics on your roof.
Montana, North Dakota, South Dakota and Wyoming, based out of Glendive, MT. Call 406-939-8301 for current lead times.
$0-down financing through Hearth — check your rate in about 60 seconds. It won't affect your credit.
See Financing OptionsTell us about your roof — we'll give you straight numbers, no upsell.
📞 Call or text 406-939-8301