Spray-foam roofing for low-slope commercial, shop, ag and metal roofs — one seamless membrane that stops leaks and adds insulation, then sealed with a protective coating that you renew instead of tearing off.
Spray polyurethane foam goes down as a single seamless layer over your existing low-slope roof — no seams or fasteners for water to find. It adds real insulation on top of stopping leaks, and a protective coating shields it from UV. When it ages, you recoat it instead of tearing it off — a roof that renews for decades.
Seamless foam self-flashes around penetrations, curbs and seams — the spots where built-up and membrane roofs usually fail.
You're insulating and re-roofing in one step — lower energy bills on shops, warehouses and ag buildings.
Recoat at the end of the coating's life instead of a full tear-off — a renewable roof, not a landfill.
Seals rusting seams and fastener leaks on shops, barns and steel buildings — common across our region.
Warehouses, storefronts and flat commercial roofs where ponding and seams are the enemy.
In many cases we spray right over the old roof — less tear-off, less downtime for your business.
We finish every SPF roof with a protective coating — acrylic or silicone depending on your roof and climate — applied to manufacturer spec. Silicone stands up to ponding water and UV on flat roofs; acrylic is a cost-effective, reflective option. The coating is what you renew down the road to keep the roof going — see our protective & roof coatings for metal, flat and foam roofs.
Based in Glendive, MT — serving the four-state region. Not listed? Call, we travel for the right job.
The foam itself is long-lived; the protective coating is the wear layer. Recoat it at the end of the coating's service life and the roof keeps going — often for decades. Call for specifics on your roof.
Often yes — SPF can go over many existing low-slope roofs after prep, which saves the cost and downtime of a full tear-off. We'll assess yours and tell you straight.
Yes — sealing leaking seams and fasteners on metal, shop and ag roofs is one of the best uses for SPF. It's a big part of what we do in this region.
An SPF roof is low-maintenance: we inspect it, keep drains and penetrations clear, and address any dings. The coating is the wear layer — when it reaches the end of its service life you recoat the same surface instead of tearing off, and the foam underneath keeps going.
Montana, North Dakota, South Dakota and Wyoming, based out of Glendive, MT. Call 406-939-8301 for current lead times.
Why a Foam Roof Wins · SPF Roof Coatings · Cool Roofs · Seamless Systems · Sustainability · Uplift Resistance · Protective Coatings
$0-down financing through Hearth — check your rate in about 60 seconds. It won't affect your credit.
Check Your RateTell us about your roof — we'll give you straight numbers, no upsell.
📞 Call or text 406-939-8301